Difference between revisions of "Visimage3 Setup for Fiserv Online Clients"
>Johno |
>Johno (→Configuring Stunnel) |
||
Line 9: | Line 9: | ||
client = yes | client = yes | ||
accept = 30501 | accept = 30501 | ||
− | connect = | + | connect = 172.21.1.40:30502 |
</pre> | </pre> | ||
− | * | + | * Change the connect IP address from 172.21.1.40 to the correct IP address of your UNIX host and save the file. |
− | * If you have already rebooted your PC since installing stunnel, stop and restart the stunnel service. Otherwise reboot. | + | *It should not be necessary to modify the accept or connect ports. |
+ | *If you have already rebooted your PC since installing stunnel, stop and restart the stunnel service. Otherwise reboot. | ||
+ | |||
=== Visimage3 Server Configuration === | === Visimage3 Server Configuration === | ||
When creating a Visimage3 connection, use the following parameters: | When creating a Visimage3 connection, use the following parameters: |
Revision as of 23:23, 8 July 2020
Visimage3 Setup
After installing Visimage3, Fiserv Online Clients must also install stunnel which is used to encrypt all communication between Visimage3 and the host. A special Fiserv installation of stunnel can be downloaded here.
Configuring Stunnel
Once stunnel has been installed you must edit the stunnel.conf file and modify the [Visimage Client] section. By default, the stunnel.conf file is located in C:\Program Files\stunnel.
Locate this section:
[VisImage Client] client = yes accept = 30501 connect = 172.21.1.40:30502
- Change the connect IP address from 172.21.1.40 to the correct IP address of your UNIX host and save the file.
- It should not be necessary to modify the accept or connect ports.
- If you have already rebooted your PC since installing stunnel, stop and restart the stunnel service. Otherwise reboot.
Visimage3 Server Configuration
When creating a Visimage3 connection, use the following parameters:
Option | Value |
Host Address | localhost |
Host Port | 30501 |
Host Profile Name | uname!live or uname!eom |
- Where uname is the username assigned by Fiserv. For example, joverton.
- The username is always followed by either !live (for the live databases) or !eom for the end of month (report) databases.