Difference between revisions of "Visimage3 Setup for Fiserv Online Clients"
>Johno |
>Johno (→Stunnel Configuration) |
||
Line 12: | Line 12: | ||
connect = 172.21.1.40:30502 | connect = 172.21.1.40:30502 | ||
</pre> | </pre> | ||
− | *Note that 172.21.1.40 is just a sample IP address, your specific address will | + | *Note that 172.21.1.40 is just a sample IP address, your specific address will be different. |
*Change the connect IP address from 172.21.1.40 to the correct IP address of your UNIX host and save the file. | *Change the connect IP address from 172.21.1.40 to the correct IP address of your UNIX host and save the file. | ||
*It should not be necessary to modify the accept or connect ports. | *It should not be necessary to modify the accept or connect ports. |
Revision as of 20:24, 5 August 2020
Visimage3 Setup
After installing Visimage3, Fiserv Online Clients must also install stunnel which is used to encrypt all communication between Visimage3 and the host. A special Fiserv installation of stunnel can be downloaded here.
Stunnel Configuration
Once stunnel has been installed you must edit the stunnel.conf file and modify the [Visimage Client] section. By default, the stunnel.conf file is located in C:\Program Files\stunnel.
Locate this section:
[VisImage Client] client = yes accept = 30501 connect = 172.21.1.40:30502
- Note that 172.21.1.40 is just a sample IP address, your specific address will be different.
- Change the connect IP address from 172.21.1.40 to the correct IP address of your UNIX host and save the file.
- It should not be necessary to modify the accept or connect ports.
- If you have already rebooted your PC since installing stunnel, stop and restart the stunnel service. Otherwise reboot.
Visimage3 Server Configuration
When creating a Visimage3 connection, use the following parameters:
Option | Value |
Host Address | localhost |
Host Port | 30501 |
Host Profile Name | uname!live or uname!eom |
- Where uname is the username assigned by Fiserv. For example, joverton.
- The username is always followed by either !live (for the live databases) or !eom for the end of month (report) databases.