UpdateMacroDefFile

From Vital Soft Wiki
Revision as of 18:12, 10 November 2014 by >Johno (Updating the Macro Definition File)
Jump to: navigation, search

Updating the Macro Definition File

The macro definition file is a text file that should be uploaded using an ASCII transfer.

Download the macro definition file here.

  • Scroll to the bottom of the page and choose the version appropriate for Visimage3 and AskPlus version E.8.3.3.

1. Transfer the file to UNIX:

  • Transfer the samp macrodef file, using an ASCII transfer, to the /ASKPLUS/visimage directory.
Using vi, verify that the file is a valid UNIX file. In vi, you should not see any ^M characters at the end of each line. If ^M characters appear at the end of each line, convert the file using the following commands.
mv macrodef_e83.samp macrodef_e83.dos
dos2ux <macrodef_e83.dos >macrodef_e83.samp

2. Backup the old definition file and copy the new one:

  • Logon to HPUX as askplus
cd /ASKPLUS/visimage
mv macrodef macrodefv26
cp macrodef_e83.samp macrodef (The downloaded macrodef file may have a different name.)
chown askplus macrodef (Make sure the file is owned by askplus)
chmod 644 macrodef

3. Rebuild the indexed macro file used by AskPlus and Visimage:

  • While still logged in as askplus
cd /ASKPLUS/visimage
rm macro (if the purge fails, make sure the file is owned by askplus)
/ASKPLUS/load_macros
Note, Visimage users will need to restart server to see the new macro definitions.
  • To kill the listener:
  • Login as root
/ASKPLUS/kill_vsrvtcp -stop_all
Note, the above command will kill all copies of the listener running on any port.
Run the load_macros script again, remember to login as the askplus user and cd visimage.
  • To restart the listener:
  • Login as root
/ASKPLUS/vsrvtcp -a -t –n30501 –a >/dev/null
/ASKPLUS/vsrvtcp_49 -a -t –n30503 –a >/dev/null
Remember to start two listeners (on two different ports) if you have users running Visimage 2.6 and Visimage3. Use port numbers appropriate on your system. Please note, the default port number is normally defined in /etc/services under the askplus entry. There is no need to specify the -n parameter to start server on the default port.

To test that the new setup is valid, start server from Visimage or run a test job that uses AskPlus.

Vital Signs users should run the following test:

  • Login as bolive
/VSJOBS/JVSLOAD_MBRSHLN
Once the job has started successfully and built at least one extract file successfully, kill the job, then clean up any created files as follows:
cd /var/summit/spectrum/LIVE/vsdata/data/mbrshln (Check /ASKPLUS/vsdata/vitalsigns.ini for the correct path)
ls (if the files are all extract files MBRFILECCYYMMDD, SHFILECCYYMMDD, etc - you are in the correct directory)
rm * (Make sure you are in the correct location before issuing this command!)
Contact support if you are unsure about any of these steps.